While the rudder pedals are
removed, I masked the firewall for sealant.
The edges must be sealed to
protect against carbon monoxide.
Masking tape is removed once the
sealant is applied.
These are the wing attach pins,
which contain a magnet switch.
Wire bundles start behind the
panel. Red bands are located on the bundles.
Here the bundles start down the
center tunnel.
Wire runs split off just behind
this bulkhead.
Center tunnel between the seats.
Center tunnel in the baggage
area.
Tail cone wiring runs.
Next step is to begin work on
the fuel tank. Those pictures can be found opn the next page.
|