The roll over structure is
added.
The rear baggage panels are
added.
The center section is complete
and ready to be mated to the empennage cone.
The empennage cone is raised
into place using the cradle. Not how the instructions say to do it but
it worked well for me.
The marriage is complete and the
cradle removed.
The rear window and skins are
fitted to the airframe.
The inside edge of the
plexiglass is painted black on the outside so the adhesive will not be seen.
The skins are riveted to the
airframe in preparation for the final window installation.
The seat backs were assembled
and installed.
The brake/rudder pedals were
assembled on the work bench and then installed.
Work continues on the fuselage.
That work can be found on the next page.
|